download the new for mac RainbowTaskbar 2.3.1

After we collected feedback to the UI improvements presented in the previous alpha, we did several tweaks to the combo boxes.

Other improvements with respect to 2.7.0-alpha1

The helical travel move was inspired by the same feature in BambuStudio. This feature is on by default once the ramping travel move is used.

Instead of going straight up to the next layer the printer head follows a helical ('screw thread') trajectory while changing layers. To fully harness the stringing reduction potential of the ramping travels moves a new layer change strategy is implemented while the ramping travel moves are active. The ramping travel moves are now enabled in our system profiles for Original Prusa XL. The ramping travel is parametrized by an angle and a maximal ramping lift: You can override the setting for each filament in the Filament overrides section. The feature can be turned on in Printer Settings->Extruder for each extruder you are using in the new Travel lift section. Now you can use the new ramping lift which ensures that the print head lifts up gradually during the travel. Such lift could result in undesirable stringing, especially while using wider nozzles. Previously you could set just the Lift height ( Printer Settings->Extruder) which resulted in the print head lifting up before each travel move and then returning back down after the travel move. To help fight stringing and oozing deposition, PrusaSlicer now implements ramping travel moves. On older firmware, new binary G-code is not visible or recognized and the G2/G3 G-codes may not work perfectly.

Users using older firmware need to update to 5.1.0-alpha2 or later or manually turn these features off. Important note for Original Prusa MINI, MK4 and XL owners: The new configuration update of our system profiles will enable binary G-code and G2/G3 features. The beta will ask whether it should import a configuration from previously run PrusaSlicer versions on the first start. To let you enjoy the beta without worries, the beta builds save their profiles into PrusaSlicer-beta directory, so you may use the beta side by side with the current release without ruining your production configuration. Read the change log of 2.7.0-alpha1 for complete list of changes with respect to 2.6.1. It brings small improvements and fixes several bugs found in the first alpha. This is the first beta release of PrusaSlicer 2.7.0.

Download the new for mac RainbowTaskbar 2.3.1